LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2017 >> X3 sDrive28i >> Repair and Diagnosis >> External Pages >> Different car >> Section 384 (Seats - Repair) >> Front Seat, Sports, Electric >> 52 16 405 Replacing backrest cover for left or right front seat

52 16 405 Replacing backrest cover for left or right front seat

WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required: 

Necessary preliminary tasks: 

Unfasten plug connection (1) and disconnect.

Fig 1: Identifying Front Seat Plug Connection
G06213131Courtesy of BMW OF NORTH AMERICA, INC.

Release all retainers from cover (1).

Installation: 

Bend new retainers closed with pliers 52 0 050 .

Remove cover (1).

Fig 2: Identifying Seat Cover
G06213132Courtesy of BMW OF NORTH AMERICA, INC.

For A/C optional extra only: 

Loosen retainers (1).

Installation: 

52 0 050 Bend new retainers closed with pliers.

Unlock plug connections (2) and disconnect.

Fig 3: Identifying Seat Retainer And Plug Connection
G06213133Courtesy of BMW OF NORTH AMERICA, INC.

Detach backrest cover all round from backrest frame.

Fig 4: Detaching Backrest Cover
G06213134Courtesy of BMW OF NORTH AMERICA, INC.

Unhook backrest cover (1) at bottom and sides towards front.

Pull off backrest cover (1) with padding towards top from backrest frame (2).

Fig 5: Pulling Backrest Cover
G04742734Courtesy of BMW OF NORTH AMERICA, INC.

Release all retainers.

Remove backrest cover (1) from padding.

Remove all remnants of clips from backrest cover (1) and padding.

Fig 6: Locating Backrest Cover Clips
G04742735Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Bend new retainer (2) 52 0 050 closed with pliers.

  1. Padding
  2. Retainer
  3. Trim wire in padding
  4. Trim wire in backrest cover
  5. Backrest cover
    Fig 7: Bending Clamp Using Pliers
    G04742736Courtesy of BMW OF NORTH AMERICA, INC.

Remove trim threads (1) from backrest cover.

(2) Seat heater cable

Installation: 

Push trim threads (1) into new backrest cover.

If necessary, cut into new component.

Fig 8: Identifying Backrest Cover Trim Wires And Seat Heater Cable
G04742737Courtesy of BMW OF NORTH AMERICA, INC.

Lever out locking strip of head restraint guide with special tool 00 9 317 .

Installation: 

Mount straight front face of head restraint guide towards front.

Fig 9: Identifying Special Tool (00 9 317)
G04742738Courtesy of BMW OF NORTH AMERICA, INC.