52 13 040 Removing and installing/replacing outer cover on left or right front seat (normal/semi-electric)

WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Normal version (basic):

Pull lever forward to remove:

If necessary, lever out lower locking point (1) from rear with a screwdriver.

Release screw (2).

If necessary, move seat fully forwards and upwards.

Semi-electric version:

Unclip cover instead of lever (2).

Release screw (2).

Fig 1: Removing Front Seat Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Remove trim:

Unclip at top edge
Unclip at rear towards top side
Pull on belt opening
Unlock lugs
Carefully remove trim towards front

Unfasten plug connection.

Replacement only:

Remove lumbar support and set adjustment switch.

Fig 2: Removing Front Seat Outer Cover Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Retaining clips and tabs must not be damaged.

Fig 3: Identifying Front Seat Switch Retaining Clips And Tabs

Courtesy of BMW OF NORTH AMERICA, INC.