22 32 001 Replacing rubber mount for transmission mounting (ATC 45L)

WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

Necessary preliminary tasks:

Remove CROSS MEMBER for transmission mounting

Attach special tool 22 1 051 with screw (1) on the housing.

Pull out rubber mount with special tools 22 1 052 /33 4 465 and 33 4 466 .

Fig 1: Pulling Out Rubber Mount

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Observe installation position of rubber mount.

Arrow on rubber mount must point to arrow on housing.

Coat housing bore and rubber mount with Circolight, refer to BMW Parts Department.

Fig 2: Identifying Rubber Mount Point On Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Insert special tool 22 1 102 with bolt into recesses of rubber mount.

Fig 3: Identifying Special Tool (22 1 102)

Courtesy of BMW OF NORTH AMERICA, INC.

Draw in rubber mount with special tools 22 1 102 /22 1 053 /33 4 465 and 33 4 466 .

Fig 4: Removing Rubber Mount

Courtesy of BMW OF NORTH AMERICA, INC.