31 35 005 Removing And Installing/Replacing Push Rod (Stabilizer Link) For Left/Right Stabilizer

WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Observe SAFETY INSTRUCTIONS for raising the vehicle
Do not mix up anti-roll bar links

Stabilizer link for conventional stabilizer
Stabilizer link for active stabilizer

Fig 1: Stabilizer Link
Courtesy of BMW OF NORTH AMERICA, INC.

Slacken nut (1).

Installation:

Replace self-locking nut.

Tightening torque 31 35 2AZ .

Fig 2: Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Slacken nut (1).

Remove stabilizer link (2).

Installation:

Replace self-locking nut.

Tightening torque 31 35 2AZ .

Fig 3: Stabilizer Link And Nut

Courtesy of BMW OF NORTH AMERICA, INC.