31 53 040 Removing And Installing/Replacing Right Output Shaft Bearing Block
WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
N62, N63:
Risk of short circuits!
There is a danger of short circuiting on account of the small distance between the bearing block screw connection and the starter motor.
Disconnect BATTERY NEGATIVE LEAD .
Risk of short circuits!
There is a danger of short circuiting on account of the small distance between the bearing block screw connection and the starter motor.
Disconnect BATTERY NEGATIVE LEAD .
Necessary preliminary tasks:
- Remove RIGHT OUTPUT SHAFT
Release screws (1).
Remove bearing block from oil sump.
Installation:
Replace O-RING .
Tightening torque 31 60 1AZ .
Replacement:
- Remove sealing caps