54 10 070 Removing And Installing/Replacing Slider Set For Floating Roofliner

WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Adhere to the utmost cleanliness.

Necessary preliminary tasks:

Remove GLASS SLIDE/TILT SUNROOF COVER AT REAR .
Remove FRONT WATER CHANNEL .

Open floating headlining (2) to the point where the screws (1) are accessible.

Release screws (1) on floating headlining holder.

Fig 1: Screws On Floating Headlining Holder

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Do not damage floating headlining rocker arm.

Pull tension springs (2) out from under floating headlining holder (1).

Fig 2: Tension Springs From Floating Headlining Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Press floating headlining (1) upward in the direction of the arrow.

Pull glider set (2) out of guide rail.

Installation note:

Observe GREASE INSTRUCTIONS for replacement parts.

Fig 3: Pulling Glider Set Out Of Guide Rail

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 4: Tensioning Springs In Recess Of Rear Floating Headlining

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Tensioning springs (1) must rest correctly in recess of rear floating headlining (2).

Insert white plastic washer on spring-mounted roof side and ensure correct position of the washer (4) with anti-twist lock.

Replace microencapsulated screws.

Tightening torque: 54 12 05AZ .