54 13 105 Removing And Installing/Replacing Rear Water Channel

WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove complete glass slide/tilt sunroof.
Remove GLASS SLIDE/TILT SUNROOF COVER AT REAR .

Unlock tab (2) and remove water channel (1) toward the top.

NOTE: 2 springs are loosely connected to the guide for the water channel.

Installation note:

Make sure that the springs are reinstalled on the supports for the water channel.

Fig 1: Water Channel And Tabs

Courtesy of BMW OF NORTH AMERICA, INC.

Removing supports for water channel:

NOTE: Water channel support cannot be removed without incurring damage.

Break out tabs with a screwdriver and lever out support.

Installation note:

Replace water channel support and hook into place.

Fig 2: Support And Tabs

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

If dirty, CLEAN GUIDE RAILS OF PANORAMA GLASS ROOF .