24 13 012 Replacing output flange radial shaft seal (GA8HP70Z) AWD
WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
IMPORTANT:
After completion of repair work, check TRANSMISSION OIL LEVEL
.
Use only the approved transmission oil. See AUTOMATIC TRANSMISSION -- OPERATING FLUIDS or DUAL-CLUTCH TRANSMISSION -- OPERATING FLUIDS .
Failure to comply with this requirement will result in serious damage to the automatic transmission!
Use only the approved transmission oil. See AUTOMATIC TRANSMISSION -- OPERATING FLUIDS or DUAL-CLUTCH TRANSMISSION -- OPERATING FLUIDS .
Failure to comply with this requirement will result in serious damage to the automatic transmission!
Necessary preliminary tasks:
- Remove transfer box
Drive a hole into radial shaft seal (1) using a center punch.
IMPORTANT:
Do not use a drill as drillings may result in transmission malfunction.
Thread special tool 23 0 490 into radial shaft seal (1).
Drive out radial shaft seal (1) with impact weight (2).
Installation note:
Coat sealing lips of new radial shaft seal with clean transmission oil.
Radial shaft seal firmly home with special tool 23 3 220 .