51 24 080 Removing and installing/replacing drive for rear lid lock

WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove TRIM FOR REAR LID LOWER SECTION

Security vehicles:

Remove rear lid lower section armor-plating

Lever out cover (1), release screw underneath and remove handle (2).

Lever out cover (3) and release screw underneath.

Installation:

If necessary, replace faulty drives (1 and 2).

Fig 1: Identifying Handle And Covers

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect Bowden cable (1 and 2).

Fig 2: Identifying Bowden Cable

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and feed out drive (2).

Tightening torque 51 24 6AZ .

Fig 3: Identifying Screws And Drive

Courtesy of BMW OF NORTH AMERICA, INC.