51 34 420 Removing and installing/replacing trim on window frame of rear door (front), left or right

WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Open rear side window
Detach COVER ON DOOR WINDOW FRAME in B-pillar area.

Detach rubber seal (1) and rubber guide (2) from trim.

Fig 1: Detaching Rubber Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Carefully detach trim (2) towards front/top.

Installation:

Moisten rubber window seal prior to fitting with water.

Fitted foam pieces must not be damaged when trim (2) is pushed in.

Fig 2: Detaching Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, replace faulty plastic nuts (1).

Make sure rubber window seal is correctly seated.

Fig 3: Identifying Plastic Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Necessary preliminary tasks:

Open rear side window

Detach rubber seal (1) and rubber guide (2) from trim.

Fig 1: Detaching Rubber Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Carefully detach trim (2) towards front/top.

Installation:

Fitted foam pieces must not be damaged when trim (2) is pushed in.

Fig 2: Detaching Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, replace faulty plastic nuts (1).

Fig 3: Identifying Plastic Nuts

Courtesy of BMW OF NORTH AMERICA, INC.