51 49 080 Removing and installing/replacing cover for loading sill (on rear lid lower section)

WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove TRIM FOR REAR LID LOWER SECTION

Lever out cover (1), release screw underneath and remove handle (2).

Lever out cover (3) and release screw underneath.

Installation:

If necessary, replace faulty drives (1 and 2).

Fig 1: Identifying Handle And Covers

Courtesy of BMW OF NORTH AMERICA, INC.

Release cover (1) at clips (2) and feed out.

Installation:

If necessary, replace faulty clips (2).

Fig 2: Removing Cover

Courtesy of BMW OF NORTH AMERICA, INC.