Preconditions for activation

WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

For technical reasons, distinctions are drawn between the following conditions required for switch-on:

Conditions required for switch-on for the FLA control unit
Conditions required for switch-on for the high-beam assistant
Conditions required for switch-on for the high-beam headlights
Conditions required for switch-on for the FLA control unit

The FLA control unit is active as of terminal 15 ON.

Conditions required for switch-on for the high-beam assistant
- Light switch set to position "A"
- Dipped headlights switched on.
  When the switch is in position "A", the dipped headlights are switched on by the automatic headlight control.
- Turn-signal/high-beam switch pressed forward (in forward direction of travel).
Conditions required for switch-on for the high-beam headlights
- Road speed greater than 50 km/h.
- Reverse gear must not be engaged.
- Image sensor does not detect an oncoming vehicle or a vehicle ahead.
- Image sensor detects adequate darkness.