51 47 490 Removing and installing/replacing front assembly underside protection
WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Illustration created using X5 3.0i as an example. There may be differences in detail in the case of other models.
Release screws (1).
Pull forward assembly underside protection (2) under bumper trim (3) and remove.
Installation:
Center underside protection (2) and tighten down screws (1).