51 15 360 Removing and installing rubbing strip on rear door on left or right

WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

NOTE: Minimum object temperature of rubbing strip and rear door ≥ 18 °C.
If this temperature is not achieved, the components must be preheated.

Removing rubbing strip:

Heat rubbing strip (1) with hot air blower and detach with special tool 00 9 317 from rear door.

Fig 1: Removing Rubbing Strip On Rear Door

Courtesy of BMW OF NORTH AMERICA, INC.

Cleaning rear door:

For cleaning, use a fluff-free disposable cloth or a clean cleaning cloth.

Clean adhesive area of rear door with spirit.

Air drying time at least 1 minute.

Do not grip bonding surface.

Fitting rubbing strip:

Pull off protective film from adhesive tape on rubbing strip (1).

Place rubbing strip (1) over holes (2) in rear door and align.

Fit rubbing strip (1) and press down firmly with special tool 51 0 300 over entire adhesive area.

Fig 2: Identifying Rubbing Strip And Holes

Courtesy of BMW OF NORTH AMERICA, INC.