51 14 110 Removing and installing/replacing rear model designation
WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
The "INSTRUCTIONS FOR NUMBER/LETTER COMBINATION CEMENTING " serve as the basis for these repair instructions and must be followed without fail.
Stick on top edge of adhesive tape (1) parallel to bottom edge of rear lid (2) at distance "A".
Mark measurement "B" from side edge (3) measured on top edge of adhesive tape.
Dimensions:
A = 20 mm; B = 57 mm
NOTE:
Measurement "C" is for information purposes only, as it is determined by carrier film.
C= 8.7 mm