36 11 105 Removing And Installing RDC (Tire Pressure Control) Control Unit

WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

Remove TRIM PANEL FOR PEDAL ASSEMBLY .

Release screws (1).

Remove air duct (2).

Fig 1: Air Duct And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Press lug (3) in direction of arrow and pull out control unit (2) towards bottom.

Fig 2: Removing Control Unit

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out PROGRAMMING/ENCODING .