11 12 040 Removing and installing all ignition coils and injector wells (N55)

WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary work:

Remove CYLINDER HEAD COVER .
Remove all INJECTORS .

Release screws (1).

Tightening torque: 11 12 8AZ .

Fig 1: Identifying Cylinder Head Cover Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Check fitting bushes (1) for damage.

Installation note:

Replace gasket (2).

Fig 2: Identifying Cylinder Head Gasket And Fitting Bushes

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.