11 12 006 Removing and installing/sealing right cylinder head cover (N63)

Special tools required: 

• 11 4 470

Necessary preliminary tasks: 

• Remove acoustic cover. See 13..... REMOVING ACOUSTIC COVERS (N63) .
• Disconnect NEGATIVE BATTERY TERMINAL .
• Release battery positive terminal. See 61 21 010 REMOVE AND INSTALL OR REPLACE BATTERY .
• Drain coolant. See 17 00 008 DRAINING AND ADDING COOLANT IN RADIATOR (N62TU, N63)
• Remove right INTERCOOLER
• Remove INTAKE FILTER HOUSING
• Disconnect FUEL DELIVERY LINE
• Detach wiring harness for injectors and lay to one side
• Remove IGNITION COILS , cylinders 1-4
• Remove injectors  . See 13 53 721 REPLACING ONE INJECTOR, CYLINDERS 1-4 (N63) , cylinders 1-4
• Remove HIGH PRESSURE PUMP

Release screws (1).

Tightening torque: 11 12 9AZ .

Remove oil filler neck (2).

Installation note: 

Replace sealing ring. 

Fig 1: Identifying Oil Filler Neck And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release bolts in sequence (17 to 1).

Remove cylinder head cover.

Fig 2: Right Cylinder Head Cover Bolts Tightening/Loosening Sequence (N63)

Courtesy of BMW OF NORTH AMERICA, INC.

Clean sealing surface (1) with special tool 11 4 470 .

Installation note: 

Replace seal (2). 

Fig 3: Identifying Sealing Surface

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Renew profile seal of cylinder head cover. 

Fig 4: Identifying Cylinder Head Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

It is important to join screw (1) for exact positioning of the camshaft sensors.

Fit cylinder head cover.

Position screw (1).

Release screw (1) by 90°.

Fig 5: Identifying Cylinder Head Cover Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Secure cylinder head cover in sequence (1 to 17) in two work steps.

Tightening torque: 11 12 3AZ .

Fig 6: Right Cylinder Head Cover Bolts Tightening/Loosening Sequence (N63)

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.

Fill and vent cooling system