12 63 586 Replacing power distribution module (N55)

WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Switch off ignition.
Disconnect BATTERY NEGATIVE LEAD .
Remove MICROFILTER HOUSING .

Lever out expanding rivet.

Release locks in direction of arrow.

Feed out fresh-air duct (1) and remove.

Fig 1: Identifying Fresh-Air Duct

Courtesy of BMW OF NORTH AMERICA, INC.

Remove cover (2).

Release nut beneath it and set positive battery cable aside.

Unlock and pull off all connectors from power distribution module (1).

Release lock (3) in direction of arrow.

Feed out and remove power distribution module.

Fig 2: Pulling Off Connectors From Power Distribution Module

Courtesy of BMW OF NORTH AMERICA, INC.

Reassemble the vehicle.