12 41 020 Removing and installing/replacing starter motor (N55)

WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Switch off ignition.
Disconnect BATTERY NEGATIVE LEAD .
Remove INTAKE PLENUM .

Unlock connector (1) and remove.

Release nuts (2) and disconnect positive battery cables.

Tightening torque: 12 42 2AZ .

Release screws (3).

Installation note:

Pay attention to the different screw lengths.

Tightening torque: 12 41 1AZ .

Tightening torque: 12 41 2AZ .

Fig 1: Identifying Starter Motor, Connector, Nuts And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Remove starter motor (4).

Installation note:

Check starter pinion and ring gear for damage. Replace starter motor if necessary.