12 14 522 Replacing pulse generator on left inlet camshaft (N63)

WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

(cylinder bank 5 to 8)

Necessary preliminary tasks:

Read out fault memory of DME control unit; if necessary, work through test schedules
Switch off ignition
Remove left INTAKE FILTER HOUSING

Unlock plug (1) and remove.

Release screw (2).

Tightening torque: 13 62 3AZ .

Remove pulse generator (3).

Installation:

Replace sealing ring and coat with antiseize agent.

Fig 1: Identifying Pulse Generator, Plug And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Now clear the fault memory.