12 14 521 Replacing crankshaft pulse generator (N63, S63)
WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Read out fault memory of DME control unit
- Turn off ignition
- Remove rear UNDERBODY PROTECTION
Installation location:
On transmission housing at bottom right.
Unlock plug (1) and remove.
Release screw (2).
Tightening torque: 13 62 4AZ .
Withdraw pulse generator (3) from transmission housing.
Installation:
clear fault memory.