34 41 220 Removing And Installing/Renewing All Parking Brake Pads
WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 34 4 000 . See 2344000 ADAPTER or 344000 HEXAGON SOCKET MECHANICAL TOOL
Installation note:
- REMOVE rear brake disk.
- Release electromechanical parking brake (EMF).
After completing repair work, ADJUST PARKING BRAKE .
NOTE:
During replacement of the hand brake coverings, the following components must also be renewed:
- Brake shoe expander
- Adjusting screw
- Spring set
Disconnect return springs (1) with brake spring pliers.
Installation note:
Return springs (1) must not be overelongated.
Check return springs (1) and replace if necessary.
Return springs (1) must not be mixed up.
Pay attention to installation position of adjusting screw (2).
Apply a thin coat of grease to bush and screw threads, refer to BRAKES - OPERATING FLUIDS .
NOTE:
Graphic without wheel hub.
Twist roll pins (1) 90° with special tool 34 4 000 . See 2344000 ADAPTER or 344000 HEXAGON SOCKET MECHANICAL TOOL and detach.
Remove brake pads (2).