34 52 535 Replacing A Rear Pulse Sensor

WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

Partially detach rear WHEEL ARCH TRIM
Read and comply with GENERAL INFORMATION .

Open housing cover (1).

Disconnect plug connection (2).

Installation:

Ensure proper locking of the plug connector and proper seating of the cable in the brackets.

Fig 1: Plug Connection And Housing Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Disengage cable (1) along marked lines from holders.

Installation:

Ensure proper locking of the holders and proper seating of the cable in the holders.

Fig 2: Cable Lines Mark

Courtesy of BMW OF NORTH AMERICA, INC.

Release Torx socket screw (1).

Withdraw wheel speed sensor (2) from bore hole.

Installation:

Tightening torque 34 51 3AZ .

Clean bore for pulse generator and lubricate with Staburags NBU 12/K lubricating grease.

Fig 3: Wheel Speed Sensor And Torx Socket Screw

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Check sensor head prior to installation for external damage, replacing if necessary.