61 35 950 Removing and installing/replacing control unit for Comfort Access System (Passive Go)

WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Necessary preliminary tasks:

Remove FLAP IN RIGHT LUGGAGE COMPARTMENT WHEEL ARCH TRIM

Lift back insulating mat (1).

Disconnect plug connection (3).

Unlock catch (2) and remove control unit for Comfort Access System (4) from device carrier (5).

Fig 1: Identifying Insulating Mat, Plug Connection, Catch, And Control Unit

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out VEHICLE PROGRAMMING/ENCODING .