61 12 062 Replacing wiring harness for front bumper
WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on HANDLING WIRING HARNESSES AND CABLES
.
Necessary preliminary tasks:
- Remove FRONT BUMPER PANEL .
NOTE:
Work is shown on the E70 by way of example. There may be differences in detail in the case of other vehicle models.
Disconnect plug connections for ultrasonic transducer (1).
Unclip or feed out wiring harness for front bumper (2) from bumper trim and remove.