00 11 500 Checking/topping up oil level in automatic transmission (GA6HP26Z)

WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Use only the approved gearbox oil. See AUTOMATIC TRANSMISSION -- OPERATING FLUIDS .
To set the correct level, it is mandatory that the service function "Transmission control unit: oil adjustment" is performed using the diagnosis system.
Failure to comply with this requirement will result in serious damage to the automatic transmission.

Installation note:

Tighten down filler plug using

Hexagon wrench 8 A/F
Torque wrench
Socket 8 A/F

Fig 1: Tightening Oil Filler Plug
Courtesy of BMW OF NORTH AMERICA, INC.

Topping up transmission oil after a repair:

Stand vehicle on a level surface and secure against rolling off.

Undo oil filler plug (1).

Installation note:

Replace sealing ring.

Top up automatic transmission fluid until it emerges from filler opening.

Start engine.

Fig 2: Identifying Oil Filler Plug

Courtesy of BMW OF NORTH AMERICA, INC.

Replenish automatic transmission fluid until it emerges from filler opening.

Screw in oil filler plug (1).

Tightening torque: 24 11 7AZ .

Press brake pedal to floor and shift through all gears several times at idle speed. Then shift to "P" position (Park).

Then check oil level.

Checking oil level:

Call up Service functions (Drive) in BMW diagnosis system
Carry out oil level check in accordance with instructions