13 62 593 Removing and installing/replacing pressure sensor on left intake plenum (N63, S63)

WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Read out fault memory of DME control unit
Turn off ignition
Remove coolant EXPANSION TANK

Unlock plug (1) and remove.

Unfasten screws (2).

Tightening torque: 13 62 2AZ .

Pull pressure sensor (3) out of left intake manifold.

Fig 1: Identifying Pressure Sensor And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Delete fault memory.