13 62 592 Removing and installing/replacing pressure sensor on right intercooler (N63)

WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Read out fault memory of DME control unit.
Switch off ignition
Remove intake duct. See 13 REMOVING INTAKE DUCT (N63) .

Unclip Bowden cable for engine bonnet/hood actuator from transverse reinforcement (1).

Detach A/C line from holder.

Unscrew left and right bolts.

Tightening torque: 51 71 4AZ .

Remove cross-brace (1).

Fig 1: Locating Transverse Reinforcement Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug (1) and remove.

Release screws (2).

Tightening torque: 13 62 7AZ .

Pull pressure sensor (3) out of right intercooler.

Installation:

Replace sealing ring on pressure sensor.

Fig 2: Identifying Pressure Sensor And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Now clear the fault memory.