13 53 330 Replacing all leakage oil lines (M57T2)

WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

13 0 170

Necessary preliminary tasks:

Switch off ignition
Remove intake air manifold. See 11 61 050 REMOVING AND INSTALLING INTAKE PLENUM (M57T2/SCR) .

IMPORTANT: It is essential to adhere to conditions of absolute cleanliness when working on the fuel system.

Do not allow any dirt particles or foreign bodies to get into the system
Use only fluff-free cloths
Remove all traces of dirt before removing pipes or individual components

Push special tool 13 0 170 in direction of arrow onto connection (1).

Fig 1: Pushing Special Tool 13 0 170 Onto Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Illustration shows injector removed:

Following procedure applies to all cylinders:

Grip connection for leakage oil line (1).

Release lock (2) with special tool 13 0 170 in direction of arrow.

Fig 2: Releasing Lock With Special Tool (13 0 170)

Courtesy of BMW OF NORTH AMERICA, INC.

Illustration shows injector removed:

Following procedure applies to all cylinders:

Detach connection (1) for leakage oil line in direction of arrow from injector (2).

Installation:

Replace sealing rings on injector.

Fig 3: Detaching Connection For Leakage Oil Line From Injector

Courtesy of BMW OF NORTH AMERICA, INC.

Release clamp (1).

Carefully detach leakage oil line (2).

Fig 4: Identifying Leakage Oil Line And Clamp

Courtesy of BMW OF NORTH AMERICA, INC.