11 11 Engine block
WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATIONS - ENGINE BLOCK
| Type | Thread | Tightening specification | Measure | ||
|---|---|---|---|---|---|
| 1AZ | Bearing cap to crankcase (ASA collar screw) | N63 | M11x102 | Replace screws | |
| Jointing torque | 20 Nm | ||||
| Torque angle | 100 ° | ||||
| 2AZ | Bearing cap to crankcase (ASA collar screw 10.9) | N63 | M8x70 | Replace screws | |
| Jointing torque | 10 Nm | ||||
| Torque angle | 55 ° | ||||
| 3AZ | Threaded support sleeves | N63 | Jointing torque | 6 Nm | |
| 4AZ | Angled screw connection to crankcase | N63 | M8x37 | Flanged head screw 10.9 | 34 Nm |
| 5AZ | Spacer bolt, oil pump | N63 | M8 | 34 Nm | |
| 6AZ | Screw plug, water drain | N63 | M14x1.5 | Replace seal | 25 Nm |
| 7AZ | Screw plug, main oil gallery rear and in V-space right | N63 | M18x1.5 | Replace seal | 25 Nm |
| 8AZ | Oil nozzle to crankcase | N63 | M12x1 | 10 Nm | |
| 9AZ | Special tool to crankcase | N63 | M8x35 | 20 Nm | |
| 10AZ | Special tool to crankcase | N63 | M10x35 | 40 Nm | |
| 10AZ | Special tool 11 8 930 to special tool 00 2 300 | N63 | M14x35 | 160 Nm | |