11 51 Coolant pump with drive
WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATIONS - COOLANT PUMP WITH DRIVE
| Type | Thread | Tightening specifications | Dimension | ||
|---|---|---|---|---|---|
| 1AZ | Coolant pump to crankcase | N55 | M8 x 26 | Replace screws. Thread repairs exclusively with aluminum Helicoil threaded insert. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 10 Nm | ||||
| Angle of rotation | 90 ° | ||||
| 2AZ | Coolant pump to holder (only for vehicles with holder). | N55 | M8 x 27 | Replace screws. Thread repairs exclusively with aluminum Helicoil threaded insert. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 10 Nm | ||||
| Angle of rotation | 90 ° | ||||
| 3AZ | Coolant hose between coolant pump and coolant thermostat. | N55 | L42-48 | 3 Nm | |
| 4AZ | Coolant hose between coolant pump and feed line. | N55 | L42-48 | 3 Nm | |
| 5AZ | Auxiliary water pump holder for EME to retaining bracket | N55, F10h/F01h/F02h/F30h | M6 x 14 | 10 Nm | |