11 31 Camshaft
WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATIONS - CAMSHAFT
| Type | Thread | Tightening specifications | Dimension | ||
|---|---|---|---|---|---|
| 1AZ | Upper and lower bearing strip of camshaft (steel screw 10.9) | N55 | M7x70 | Insert screws dry | |
| Jointing torque | 8 Nm | ||||
| Angle of rotation | 60 ° | ||||
| 2AZ | Eccentric shaft bearing cap to cylinder head | N55 | M6x27 | 8.5 Nm | |
| 3AZ | Camshaft bearing cap to cylinder head | N55 | M6x30.5 | 8.5 Nm | |
| 4AZ | Chain drive module to cylinder head | N55 | M6x35 | 8 Nm | |
| 5AZ | Guide rail to crankcase | N55 | M8 | 20 Nm | |
| 6AZ | Guide rail to cylinder head | N55 | M7 | 14 Nm | |
| 7AZ | Chain tensioner to cylinder head | N55 | M22 x 1.5 | Do not retighten the chain tensioner. Replace sealing ring, thread lightly oiled |
55 Nm |
| 8AZ | Screw plug in cylinder head | N55 | M18x1.5 | 25 Nm | |