32 41 100 Removing And Installing/Replacing Belt Pulley On Vane Pump For Hydraulic Steering
WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Carry out preliminary work as described in REMOVING AND INSTALLING/REPLACING DRIVE BELT FOR ALTERNATOR (M57T2)
, REPLACING DRIVE BELT FOR ALTERNATOR (N63)
or REPLACING DRIVE BELT FOR ALTERNATOR (N55)
.
Slacken screws (1)
Relieve tension on drive belt and remove from belt pulley (2). See REMOVING AND INSTALLING/REPLACING DRIVE BELT FOR ALTERNATOR (M57T2) , REPLACING DRIVE BELT FOR ALTERNATOR (N63) or REPLACING DRIVE BELT FOR ALTERNATOR (N55) .
Unscrew bolts (1) and remove belt pulley (2).
Installation note:
Lettering on belt pulley (2) must point forwards.
Replace microencapsulated screws.
Tightening torque: 32 41 2AZ .