33 00... Rear Axle: Wheel/Chassis Alignment Check Must Be Carried Out After The Following Work
WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
A wheel/chassis alignment check must be carried out after the following work: See 32 00 150 KDS WHEEL ALIGNMENT WITH VEHICLE LOAD UP TO DESIGN POSITION or 32 00 155 KDS CHASSIS/WHEEL ALIGNMENT CHECK WITH RIDE HEIGHT MEASUREMENT WITHOUT VEHICLE LOAD .
- Release of following screw/bolt connections:
- Swinging arm, front/rear, to rear axle carrier
- Swinging arm to integral link/wheel carrier
- Integral link to wheel carrier
- Guide arm to rear axle support
- Wishbone to rear axle support
- Replacement of following parts:
- Rear axle support
- Swinging arm
- Integral link
- Wheel carrier/ball joint
- Wishbone
- Guide arm