Storage Location

WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Consisting of:

Fig 1: Device (0491850)

Courtesy of BMW OF NORTH AMERICA, INC.

0491851 Spindle
NOTE: With 2 nuts and 2 washers
0491852 Bush
NOTE: (Slip bush) For installing the rubber mount in the front axle support
0491853 Bush
NOTE: (Bush) For removing the rubber mount from the front axle support, for removing and installing the rubber mount in the wishbones and for press-fitting the taper roller bearing of the rear axle differential housing
0491854 Pipe
NOTE: (Support tube) For installing the rubber mount in the front axle support - series: E12
0491855 Washer
NOTE: (Flanged washer) For centering of threaded spindle and as a support disc for removing and installing the rubber mount in the front axle support and in the wishbones - series: E12
0491856 Synchronizing key
NOTE: For removing and installing the rubber mount in the front axle support - series: E12
0491857 Bush
NOTE: For installing the rubber mount in the front axle support - series: E12
0491858 Bush
NOTE: (Bush) For installing the rubber mount in the front axle support and thrust piece, for removing and installing the rubber mount in the wishbones
0491859 Bush
NOTE: (Bush) Deletion, only available via tool set