61 35 095 Removing and installing/replacing control unit/module for seat heating
Attention!
READ AND COMPLY WITH NOTES ON PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .
NOTE:
To facilitate installation/removal of control unit, move seat upwards and to the rear fully.
Removal:
Detach and remove control unit/module for seat heating (1) in direction of arrow from holder (3) and guide (2).
Release and detach all connectors (1) from control unit/module for seat heating (2).
Installation:
Connect all connectors (1) to control unit/module for seat heating (2).
Insert control unit/module for seat heating (1) in direction of arrow into guide (2) and holder (3).
Installation note:
Check control unit/module for seat heating (1) is correctly seated and latched into place.