26 11 Propeller Shaft. complete
WARNING: This page is about a different variant/trim than selected.
26 11 PROPELLER SHAFT (COMPLETE) TIGHTENING TORQUES SPECIFICATION
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Propeller shaft plugged into transfer box PTO (insert nut) | F45 ALL/F46 ALL/F48 ALL/F49 ALL | Torque | 80 Nm | |
| 2AZ Rear flexible disc to rear axle final drive | F45 ALL/F46 ALL/F48 ALL/F49 ALL | M12X1.5 | Replace screws; jointing torque and angle of rotation must be observed without fail. | |
| Jointing torque Angle of rotation |
55 Nm 90° |
|||
| 3AZ Flexible disc, rear, to propeller shaft | F45 ALL/F46 ALL/F48 ALL/F49 ALL | M12X1.5 | Replace screws and nuts; jointing torque and angle of rotation must be observed without fail. | |
| Jointing torque Angle of rotation |
55 Nm 90° |
|||
| 4AZ Center mount to body | F45 ALL/F46 ALL/F48 ALL/F49 ALL | M8 | 19 Nm | |
| 5AZ Front propeller shaft to rear propeller shaft (flange nut) | F45 ALL/F46 ALL/F48 ALL/F49 ALL | Replace flange nut, circlip, sealing ring. | 90 Nm |