00 11 229 Oil change in manual gearbox (GS6-60DA)
WARNING: This page is about a different variant/trim than selected.
Recycling:
Catch and dispose of escaping transmission oil.
Observe country-specific waste disposal regulations
NOTE:
Gearbox is at normal operation temperature.
IMPORTANT:
Use only the approved transmission oil.
Refer to: MANUAL TRANSMISSION - OPERATING FLUIDS
Failure to comply with this instruction will result in serious damage to the transmission.
, see operating fluid capacityTECHNICAL DATA
The vehicle must be parked on a level surface in the workshop during transmission oil filling.
Refer to: MANUAL TRANSMISSION - OPERATING FLUIDS
Failure to comply with this instruction will result in serious damage to the transmission.
, see operating fluid capacityTECHNICAL DATA
The vehicle must be parked on a level surface in the workshop during transmission oil filling.
Unscrew oil drain plug (1) and allow oil to flow out completely.
Clean oil drain plug and reinstall.
Tightening torque, refer to: 23 00 2AZ.
IMPORTANT:
Make sure during removal of the filling/level control screw to note the installed filling/level control screw variant.
It is mandatory to use variant 1 in transmissions up to production date 08/2015.
It is mandatory to use variant 2 in transmissions from production date 08/2015.
It is mandatory to use variant 1 in transmissions up to production date 08/2015.
It is mandatory to use variant 2 in transmissions from production date 08/2015.
Failure to comply with this instruction will result in leaks on the transmission.
Variant 1 until production date 08/2015.
Variant 2 from production date 08/2015.
Unscrew filler/fluid level monitoring connector (1) and fill the transmission until the oil overflows.
Allow surplus oil to drain off.
Screw in the filling/level control screw (1).
Parts: Replace the filling/level control screw (1).
Tightening torque, refer to: 23 00 2AZ. .