0000 Tires: checking and if necessary correcting inflation pressure, checking condition, tread depth and pattern
WARNING: This page is about a different variant/trim than selected.
- Checking tire pressure:
- Check tire pressure in accordance with label on B-pillar
- Check tire condition:
- Check tread depth of all tires with tire tread gauge
- Check tire tread surfaces and side walls for incisions and foreign particles such as nails or screws
- Check tread wear pattern for localized flattening and wear on one side; if necessary, carry out wheel/chassis alignment after consulting with customer and issue a separate invoice for this work
NOTE:
- For details of approved wheel and tire combinations, refer to the appropriate BMW catalogue.
- For reason of driving safety, only use tires of the same design and tire tread on a single vehicle
- Inform customer of any incorrect or worn tires