31 12 Axle guide and struts
WARNING: This page is about a different variant/trim than selected.
31 12 AXLE GUIDE AND STRUTS - TIGHTENING TORQUES SPECIFICATION
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Wishbone to swivel bearing | F39/F45/F46/F48/F49/F52 | M10 | Exclusively use the screw to tighten! Replace screw and nut. |
60 Nm |
| 2AZ Wishbone to front axle support | F39/F45/F46/F48/F49/F52 | M12 | Tighten in normal position! Replace screw. Jointing torque Angle of rotation |
100 Nm 90° |
| 3AZ Holder, wishbone rubber mount, to front axle support | F39/F45/F46/F48/F49/F52 | M12 | Replace screws. Observe installation position of the screws - different lengths! |
100 Nm |
| 4AZ Holder, wishbone rubber mount, to body | F39/F45/F46/F48/F49/F52 | M10 | Replace screws. Jointing torque Angle of rotation |
56 Nm 90° |