22 11 Engine mounting
WARNING: This page is about a different variant/trim than selected.
22 11 ENGINE MOUNTING - TIGHTENING TORQUES SPECIFICATION
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Engine mount to cylinder head | F45/F46/F48/F49/F52 | M10 10.9 | Replace screws Jointing torque Angle of rotation |
40 Nm 90° |
| 2AZ Engine mount to side member | F45/F46/F48/F49/F52 | M12 10.9 | 100 Nm | |
| 3AZ Engine mounting bracket to cylinder head | F45/F46/F48/F52 | M10 8.8. | 41 Nm | |
| 4AZ Holder with rubber mount to oil sump | F45/F46/F48/F49/F52 | M12 10.9 | 100 Nm | |
| 5AZ Holder with rubber mount to front axle support | F39/F45/F46/F48/F49/F52 | M12 10.9 | 100 Nm |
| Engine mounting bracket to engine mount | ||
| M10 | 56 Nm | |