24 61 007 Removing and installing or replacing EGS (AISIN F22AW)

Necessary preliminary work: 

• Disconnect the BATTERY EARTH LEAD
• Remove the INTAKE SILENCER HOUSING

Removal: 

Release ball socket (1) from ball stud.

Release cable (2) from support angle.

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock connector (1).

Release clamp (2) with wiring harness from transmission and place to one side.

Courtesy of BMW OF NORTH AMERICA, INC.

Slacken nut (1).

Remove selector lever (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Before removal of the EGS, lever (1) must point towards "N".

Arrows (2) must point to each other.

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove EGS (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Pins (1) of sealing sleeve (2) must not be touched.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Before installation of the EGS, lever (1) must point towards "N".

Arrows (2) must point to each other.

Courtesy of BMW OF NORTH AMERICA, INC.

Install EGS (2).

Tighten down screws (1).

Tightening torque, refer to: 24 61 1AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Install selector lever (2).

Tighten nut (1).

Tightening torque, refer to: 24 61 2AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Press in cable (2) into support angle.

Ensure cable counter support audibly engages.

Press on ball socket (1) onto ball stud.

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: 

• Install the INTAKE SILENCER HOUSING
• Connect the BATTERY EARTH LEAD

Replacement: 

Carry out VEHICLE PROGRAMMING/CODING .