24 21 221 Replacing left radial shaft seal on differential (AISIN F22AW) All-wheel drive vehicles
WARNING: This page is about a different variant/trim than selected.
Special tools required:
- 23 0 490
- 2 405 249
Necessary preliminary tasks:
- Remove the LEFT OUTPUT SHAFT .
- Remove the INTAKE FILTER HOUSING .
Removal:
Drive a hole into radial shaft seal using a center punch.
IMPORTANT:
Do not use a drill as swarf may result in transmission malfunction.
Thread special tool 23 0 490 into radial shaft seal (1).
Drive out radial shaft seal (1) with impact weight (2).
Installation:
Installation note:
Coat sealing lips of new radial shaft seal (1) with clean transmission oil.
Radial shaft seal firmly home with special tool 2 405 249 .
Required follow-up work:
- Install the LEFT OUTPUT SHAFT .
- Check TRANSMISSION OIL LEVEL .
- Install the INTAKE SILENCER HOUSING .