24 11 172 Replacing the gearbox breather (AISIN F22AW)
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
- Check breather for completeness after removal.
- Broken-off breather retaining lugs will result in serious damage to and failure of the automatic transmission.
Necessary preliminary tasks:
- Remove the BATTERY
Removal:
Release screws (1).
Release partition wall (2) from bracket and remove.
Release control unit (3) from bracket.
Detach wiring harness (4) from battery tray (5).
Remove battery tray (5).
Release screw (1).
Lever breather (2) out of transmission housing with a suitable tool.
Check breather for completeness.
Retaining lugs (1) must not be broken off and be left behind in the transmission.
Installation:
Push breather (2) into the transmission housing.
Tighten screw (1).
Install battery tray (5).
Tighten down screws (1).
Install wiring harness (4) on battery tray (5).
Insert control unit (3) in bracket.
Insert partition wall (2) in bracket.
Required follow-up work:
- Install the BATTERY