24 00 161 Installing exchange gearbox (AISIN F22AW)

WARNING: This page is about a different variant/trim than selected.

Attention!

Transmissions are filled with fluid. Oil level does not have to be compensated!

Only in the event of discernible external damage to exchange transmission or discernible oil leakage from exchange transmission - check OIL LEVEL .

After completing work:

Only use the approved automatic transmission fluid. Refer to: AUTOMATIC TRANSMISSION - OPERATING FLUIDS
Reset adaptation values.
Perform clutch and gear ratio adaptation.

Failure to comply with this requirement will result in serious damage to the automatic transmission!

Recycling:

Catch and dispose of escaping transmission oil.

Observe country-specific waste disposal regulations

Necessary preliminary tasks:

Remove the automatic TRANSMISSION (without wheel alignment!) .

Remount the following parts.

Converter, transportation retainer (1).
Remount the gear selector cable holder

Courtesy of BMW OF NORTH AMERICA, INC.

Attention!

In the case of a transmission exchange, the associated heat exchanger for heating system/transmission oil cooler must always be replaced as well. (F48/F49 B48/47)

Failure to comply with this instruction may result in serious damage to the automatic transmission.

Required follow-up work:

Install the automatic TRANSMISSION (without wheel alignment!) .