18 20 Exhaust system mounting
WARNING: This page is about a different variant/trim than selected.
18 20 EXHAUST SYSTEM MOUNTING - TIGHTENING TORQUES SPECIFICATION
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Exhaust system to catalytic converter | B38/B48 | Ribbon cable clamp | If necessary, replace clamp. | 26 Nm |
| B38/B48 | V-band clamp | If necessary, replace clamp. | 22 Nm | |
| 2AZ Exhaust system to body | B38/B48 | M8 | Replace nut. | 19 Nm |
| 3AZ Rear silencer to center silencer/gasoline particulate filter | B38/B48 | 26 Nm |
| Clamp with partial replacement of exhaust system | ||
| Clamp | Tightening torque | 45 Nm |
| V-ribbon clip to catalytic converter | ||
| V-ribbon clip Replace V-ribbon clip. |
tightening torque | 25 Nm |