22 11 095 Removing and installing/replacing holder with rubber mount

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary work:

Removal:

Attention!

Support engine with lifter.

Undo bolts (1) and remove the holder (2) with rubber mount.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Install holder (1) with rubber mount.

Tighten down screws (2).

Tightening torque 22 11 4AZ .

Tighten screw (3).

Tightening torque 22 11 5AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: