11 27 Dual-mass counterbalance shaft and idler gear
WARNING: This page is about a different variant/trim than selected.
11 27 DUAL-MASS BALANCE - TIGHTENING TORQUES SPECIFICATION
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Gear to counterbalance shaft | B46M0/O0/B48M0/O0 | M10 |
|
20 Nm 180° |
| 2AZ Idler gear to crankcase | B46M0/O0/B48M0/O0 | M12 |
|
10 Nm 45° |
| Special tool 2 288 054 to crankshaft | |
| tightening torque | 20 Nm |