11 12 719 Grinding cylinder head lower face (B48AO0)
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary tasks:
- Remove CYLINDER HEAD .
- Check CYLINDER HEAD FOR WATERTIGHTNESS
Check evenness of cylinder head lower face with a standard straightedge (1).
NOTE:
Max. deviation from flatness (longitudinal) 0.10 mm
Check evenness of cylinder head lower face with a standard straightedge (1).
NOTE:
Max. deviation from flatness (transverse) 0.05 mm
Required follow-up work:
- Install the CYLINDER HEAD